Roll Up Door Top Draft Stop Seal

The Janus Roll Up Door Top Draft Stop Seal is an EPDM replacement weather seal designed to close the gap along the top of compatible Janus rolling steel doors. The seal mounts to the door curtain and helps form a barrier between the rolling door and the building opening. Its profile measures approximately 2.625 inches high and includes a 0.75-inch mounting flange with a 0.125-inch rounded sealing edge.

Made in the USA by Action Industries, the flexible EPDM rubber construction is suited for regular exposure to changing temperatures and demanding roll-up door environments. It helps reduce air infiltration while limiting dust, debris, insects, and other pests from entering through the upper door opening. This seal is sold by the foot and supplied as one continuous piece in the quantity ordered.

Why Choose This Roll Up Door Top Draft Stop Seal?

• Helps close the gap along the top of compatible rolling steel doors
• Reduces unwanted drafts and air infiltration through the upper opening
• Helps limit dust, debris, insects, and pests from entering the building
• Flexible EPDM construction supports consistent sealing contact
• Suitable for replacement and roll-up door weather-sealing applications
• Made in the USA by Action Industries

Choosing Your Weather Seal

Confirm the profile dimensions and mounting arrangement of your existing top draft stop before ordering. This seal is intended for compatible Janus rolling steel doors and is the same seal as Janus part number HDWR110104-0000.

Technical Specifications

Package Includes

• EPDM rolling door top draft stop seal

Installation Best Practices

This top draft stop mounts to the rolling door curtain. Before installation, inspect the mounting area and confirm that the seal profile and position match the existing door configuration.

• Fully close the door and mark the draft stop mounting location before raising the curtain.
• Measure the door opening rather than relying on the old seal, which may have stretched, shrunk, or been trimmed.
• Clean the curtain surface and remove dirt, rust, or debris that could interfere with secure mounting.
• Raise the curtain only far enough to make the marked mounting area safely accessible.
• Attach the seal approximately every 12 inches using 1/4-inch-diameter by 3/4-inch-long TEK screws and flat washers (not included).
• Confirm that the seal makes consistent contact across the full top opening before trimming any excess material.

TEK screws and flat washers are required for the illustrated installation method but are not included with the seal.

Compatibility Notice

Garage door designs can vary, and retainer shapes and sizes may have changed over time. Please double-check your existing retainer or track before ordering and contact us with photos or measurements if you need help choosing the right seal.

Frequently Asked Questions

Is this the same seal as Janus part number HDWR110104-0000?

Yes. This Action Industries top draft stop is identified as the same seal as Janus part number HDWR110104-0000.

Are the installation fasteners included?

No. The TEK screws and flat washers shown in the installation guidance are not included.

Can the seal be trimmed after installation?

Yes. Install and center the seal first, verify coverage across the full door width, and then trim any excess material.

How much top draft stop seal should I order?

Measure the full width of the rolling door curtain and enter the required number of feet in the Quantity box. The ordered footage will be supplied as one continuous piece.