2" ID, .225 Wire, 27" LW Torsion Spring

This left-wind torsion spring is designed for residential sectional garage door systems requiring a 2" inside diameter and .225 wire size. With a 27" overall length, it provides consistent torque to help maintain proper door balance and smooth lifting performance. Factory-installed winding and stationary cones reduce setup time and support efficient spring replacement during installation.

Key Specifications

• Inside Diameter: 2"
• Wire Size: .225"
• Overall Length: 27"
• Wind Direction: Left-Wind
• Material: Oil-tempered spring steel
• Cones: Winding and stationary cones pre-installed

Material and Construction

Constructed from oil-tempered spring steel, this torsion spring is engineered to handle the repeated opening and closing cycles common in residential garage door systems. The material provides dependable strength and flexibility to maintain stable torque and balanced door operation.

Compatibility

This spring is compatible with standard 2" torsion shaft assemblies used on residential and light commercial sectional garage doors. The left-wind configuration is typically installed on the right side of the center bracket when viewed from inside the garage.

Installation Advantage

Pre-installed winding and stationary cones allow the spring to be mounted directly onto the torsion shaft, helping installers complete replacements efficiently while minimizing additional field preparation.

Part Number

• 2-225-27L – 2" inside diameter, .225 wire size, 27" length, left-wind torsion spring with cones installed

Important Safety Notice

WARNING: Torsion springs are under extreme tension and can cause serious injury or property damage if handled improperly. Installation and adjustment should only be performed by trained professionals using proper tools and established safety procedures.