If your garage door opener system isn’t working correctly, replacing your circuit board may restore functionality back to your system and prevent you from replacing the entire system, saving you time and money. Common problems, such as nonresponse keypads and remote controls, can be due to a faulty circuit board. Fortunately, we carry replacement circuit boards for every Chamberlain LiftMaster model.
The 41A5483-4B circuit board is compatible with Chamberlain 3280 Formula I and LiftMaster 2280 1/2 HP systems. Once your circuit board is successfully installed, it is important to adjust its programming to ensure safety. To test your safety reverse system, take the following steps:
• With the door fully open, place a one inch board under the center of door.
• Close the door. When the garage door hits the board, it should reverse directions immediately.
• If the door only stops on the board but does not reverse directions, increase the Down limit by turning the adjustment screw 1/4 counterclockwise.
• If the door reverses after adjustment, remove the board and run the door three to four full cycles to ensure your system’s adjustments are correct.
Most faulty circuit boards are due to power surges or lightning strikes. For this reason, we recommend using a
990LM Garage Door Opener Surge Protector to safeguard your new Chamberlain 41A5483-4B circuit board, ensuring your system functions correctly in the future.